Tag Archives | oak

66 Slats / 198 Fasteners

By reed on November 8, 2013 in Tables

With the white oak slats twisted into shape and drying it was time to layout exactly where each slat was going to attach to the frame and drill holes in the steel frame for where the fasteners would go. It took a few tries to get the spacing right with the dividers, a centreline was scribed and the holes were set with a punch and hammer. The steel base was clamped down to the bed and using a jig that held the drill parallel to the bed 198 holes were drilled through the 3/16″ thick steel. 37.25″ of lineal steel were drilled through over the course of two days.

As the 66 wood slats got fit into place the same drill jig was used to drill out the wood slats for the fasteners.

Twist and Shout!

By reed on November 5, 2013 in Playing Around, Tables

A little while back we were twisting the 3/4″ thick by 2″ wide by 34″ long white oak slats to make up Dining Table No 1. We were doing this with kiln dried wood, which typically speaking doesn’t steam bend all that well, but given that the most extreme twists for the table are around 45 degrees we tested it out, and it seemed to work without any problems. After one long day and some 70 slats twisted and clamped to the metal base to dry we decided to “test the limits” with the few that remained in the steam box. The slats were steamed for roughly 2-3 hours at 200+ degrees fahrenheit, the results were pretty incredible, to watch the bending happen check out this video.

Let the twisting begin!

By reed on October 5, 2013 in Tables

Dining Table No. 1 is going to consist of 66 twisted wood slats twisted to 16 different angles. We are using 3/4″ thick kiln dried white oak that will be steamed at 200+ degrees fahrenheit for around 2 hours. Here is a video of the twisting in action. Clamps, we also needed a lot of clamps, seriously.

Dining Table No. 1 Sketch

By reed on September 29, 2013 in Tables

Incorporating metal into my furniture is something I have a growing interest in as of late. It opens new doors for pushing the boundaries of traditional construction and forms. Below is a sketch of a dining table commission, it will at some point be a metal frame that will house 66 twisted wood slats in the weeks to come. Stay tuned for updates of the process and headaches that will surely follow.

Steam Twisting

By reed on August 13, 2013 in Tables

First post on the new blog, allow me to introduce myself, my name is Reed Hansuld and I design / build custom furniture.

I plan on using this blog as a place to spotlight the process of making my ideas reality. Enjoy! I am going to start with a video we shot last week of a kiln dried white oak blank being steam twisted. Dimensions are approximately 3/4″ x 2″ x 34″. We were steaming and twisting 60+ blanks over the weekend in preparation for a dining table that will be constructed over the next couple weeks. Stay tuned for updates of the process.

Main